[Elecraft] K2 CW R problems

[Gordon LaPoint]

Never mind, Operator error, I was holding REV   NOT CW REV button.   All 
is fine in K2 Land!

Gordon - N1MGO

On 4/1/2018 7:51 AM, Gordon LaPoint wrote:
> I finished building my K2, finished alignment and all works fine. I 
> since installed the SSB and AF filter.   Starting the CAL FIL setup I 
> decided to lower the CW Tone from 750Hz to 650 Hz so I needed to do 
> the CAL FIL complete including the CW Filters.   I can not get the K2 
> to go to CW R mode.  The A/B [REV] button only switches between VFO A 
> and B   A hold of the button does not activate CW R, What do I have 
> setup wrong?
> The modes do step through CW, U and L normally, I do have the OP1 
> filter showing up, I have not enabled RTTY mode.
>
> Thanks,
> Gordon - N1MGO