[Elecraft] KXPD2 - Iambic B

[Bob McGraw K4TAX]

The numbers I use for spacing and pressure for all of my keys, single 
lever paddle, dual lever paddle and straight keys are as follows.

Contact spacing is adjusted with an automotive type or machinist type 
feeler gauge to .005" or 0.13mm

The pressure to close the contact, measured at the tip of the level is 
20 to 30 grams measure with a push type spring scale.

All of my keys are adjusted accordingly.   Thus changing from one to 
another is not an issue.

73

Bob, K4TAX


On 9/22/2017 10:05 AM, Brian Hunt wrote:
> I initially had a similar problem - KXPD2 failing to key dahs properly/reliably. The main reason was the contact spacing was too close. I like a light touch and close spacing. I spent quite a bit of time adjusting the pivot pin play using the small allen wrench provided. You want them tight enough to not allow the paddle to "wobble" but not so tight that it binds. Once those adjustments are made, set the contact spacing where you like it but wide enough for the "swing" needed to make reliable contact. You can also use a small strip of stiff paper slid between the contacts to clear out any dust or corrosion.
>
> 73,
> Brian, K0DTJ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>