[Elecraft] KXPD2 - Iambic B

[G4GNX]

That paddle behavior is not correct.

I suspect that you have either a faulty paddle or it's just badly adjusted, 
with the contacts too close.

I've had a paddle give strange results, where one paddle pulled on the 
wiring when operated, which in turn pulled the wire on the opposite paddle 
and made it operate too.

AFAIK there's nothing in software/firmware to allow that behavior to be set.

73,

Alan. G4GNX

-----Original Message----- 
From: MaverickNH
Sent: Friday, September 22, 2017 1:37 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KXPD2 - Iambic B

Just starting to use my KPXD2 paddles on my KX2. I have them set to Iambic 
B.
The left paddle will give only dits if pressed and held any length of time.
The right paddle when pressed will give either dahs or fits and dahs,
depending on length of press. I can do a R or K by pressing the right paddle
alone.

My other dual paddles don't do that. Am I missing something? I've removed
and replaced a few times.

Bret/N4SRN



--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to g4gnx at g4gnx.com