[Elecraft] Question for Wayne about your OCF Dipole

[Alan]

Yes, I agree the shields should be connected together at both ends.

I believe the loss is the same as a single run of coax.  Each coax has 
only half the loss since it carries only half the power, but there are 
two of them so the total loss is the same.

That assumes the SWR is the same in both cases.  If 100 ohms is a better 
match than 50 ohms, then the loss will be lower in the parallel 
configuration.

Alan N1AL


On 09/18/2017 05:31 PM, Don Wilhelm wrote:
> Wayne,
> 
> Actually, parallel coax runs make a good choice for shielded parallel 
> feedline.  The paralleled LMR-400 lines should produce a feedline 
> characteristic impedance of 100 ohms.  It is normal to connect the 
> shields together at both ends.  At the antenna, the connected shields 
> are left floating, but at the rig end, are connected to chassis common 
> (your BL2 ground lug) - perhaps "floating" is what you meant by 
> "unterminated".  Are the shields connected at the antenna end?
> 
> As I recall, the matched impedance loss would be twice the loss of a 
> single run of the coax, but at reasonable distances and the low loss of 
> LMR-400, it should not be a problem at HF.
> 
> The advantages of using parallel coax for a balanced feedline is the 
> same as using coax over open-wire or ladderline.  It can be run on or in 
> the ground, run next to or thorough conducting metallic surfaces, or 
> coiled up with no ill effects.  Open wire and ladderline takes more care 
> in its installation and must use gentle turns and be spaced away from 
> nearby conducting objects.
> 
> 73,
> Don W3FPR
> 
> On 9/18/2017 6:02 PM, Wayne Burdick wrote:
> 
>>
>> The experimental feedline, running under the house for half its 
>> length, was more deliberate if not justified in the literature. At 
>> first I was using 300 ohm mystery twin-lead scavenged from an 
>> installation of yore. But given all the RFI sources I decided to try 
>> two lengths of LMR-400, taped together every few feet, forming a 
>> sortof-balanced-shielded feed. Purists I consulted ahead of time 
>> continue to be shocked at how well this works. At the mast, the 
>> grounds are left unterminated. In the shack, the two center conductors 
>> go to an Elecraft BL2 balun. The shields are soldered together and 
>> connected to the BL2’s ground lug.
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>