[Elecraft] TX Mode issue

[Jim Brown]

On 9/8/2017 2:47 PM, Wes Stewart wrote:
> Any ideas? 

Only a WAG, Wes. All of the Elecraft radios write their current setup to 
RAM when you turn off the radio with its own power switch, and the next 
time the radio is turned on, that setup is applied. If, however, you 
remove DC power from the radio, those settings are NOT written, and the 
last settings saved will apply.

Also, if the radio is running and power is interrupted for some reason, 
the radio can go a bit nuts. This happened to me once when I was running 
from the 12V line in my Toyota SUV without the motor running and power 
dropped for a few seconds when I started the motor. In my case, it 
locked up. Taking advice from K6XX, I removed power from the radio, let 
it sit for 20 minutes, and turned it back on. As I recall, that's all I 
had to do, and it fired up.

73, Jim K9YC