[Elecraft] OT - WSJT-X & K3s

[Bob McGraw K4TAX]

Connect the K3S direct to a USB port on the computer.   Most likely LP 
Bridge is causing the issues.    Also If you experience issues with 
WSJT-X  V1.8 I have found it must be installed in its own directory 
under C:// and not into a program directory.    It will make its own 
directory by default.

I'm very successfully using WSJT-X v1.8,0-RC1 with Windows 10 and my 
K3S.   If you need screen shots, I'll be glad to make available.

73

Bob, K4TAX


On 9/3/2017 4:47 PM, Gary Smith wrote:
> I'm sure this has been asked before but I
> am not finding the solution, the story of
> my life...
>
> I just loaded WSJT-X into the Windows 10
> computer & I have a K3s. I have been
> following the user's guide found here:
> https://www.physics.princeton.edu/pulsar/K
> 1JT/wsjtx-doc/wsjtx-main-1.7.0.html
>
> I am using LP Bridge to give me a unique
> serial port ( 11 ).
>
> In setting up the radio I have followed (I
> think I have followed) the instructions
> but when I click Test CAT I get a failure.
> I tried selecting the different clickable
> options but have no success, it always
> comes up as a failure. I successfully run
> MMTTY and N1MM with no issues. I am having
> difficulty getting the audio to run from
> the computer but that doesn't seem to
> bother N1MM & MMTTY operation.
>
> After much googling I have resorted to
> asking here for suggestions.
>
> If there is a user's group that has people
> familiar with WSJT and the K3/K3s that I
> can get info from, that would be better
> than using the bandwidth here.
>
> Thanks & 73,
>
> Gary
> KA1J
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>