[Elecraft] PA Transistors Maintenance in K2

[Mel Farrer]

Ted,
 If the people at Elecraft have done their job and mounted the transistor properly with the correct torque on the mounting hardware procedure, no additional maintainance is required. I have been in the industry for a LONG time .  Three things to remember in the mounting of any RF or high power device.  Flat surfaces, minimual mating gu, and required torque. Lack of any of these will kill a device if not correct.  I have never required retorqueing parts, with one exception.   In 000 copper wire terminals, the copper does relax and needs to be retorqued to achieve a gas tight seal connection, but that is in industrial application.  Small RF devices only need the initial torque to be correct.

Mel, K6KBE

      From: Cameron Francey <cameronfranceyutils at hotmail.com>
 To: "Dauer, Edward" <edauer at law.du.edu>; "elecraft at mailman.qth.net" <elecraft at mailman.qth.net> 
 Sent: Saturday, October 28, 2017 12:10 PM
 Subject: Re: [Elecraft] PA Transistors Maintenance in K2
   
A nice tip which I use when looking for anything in any sort of .pdf manual, Elecraft included as I have accumulated quite a number of them over time is to use the search feature on the .pdf reader.  Ctrl+f on WIndows and cmd+f on Mac and type what I'm looking for.  The index and contents tables are good, but obviously can't have everything in them, so I use the find feature a lot.


Hope this helps.


Regards, Cameron - AF7DK/GM7LQR


________________________________
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> on behalf of Dauer, Edward <edauer at law.du.edu>
Sent: Friday, October 27, 2017 8:15 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] PA Transistors Maintenance in K2

I vaguely remember reading somewhere that after some number of hours of operation – maybe 50 – the hardware holding Q7 and Q8 onto the heat sink should be tightened, I presume to maintain good heat conduction from the tabs to the sink.  But I can’t find that instruction in the manual now.  Anyone know where I might have gotten that notion, or did I just make it up?

Thanks,

Ted, KN1CBR


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to cameronfranceyutils at hotmail.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to farrerfolks at yahoo.com