[Elecraft] KXPD3 problem - solved

[Ignacy]

The problem appeared suddenly. When KXPD3 was inserted, KX3 started sending
dahs. With KXPD3 not fully screwed, keying was OK. 

What happened was that the two bottom pins in KX3 that mate with KXPD3
recessed, touching connections with the upper pins. Then, the ground pin
became the dah pin.  When KXPD3 was not fully inserted, the recessed pins
did not make contact; the ground connection was through the screws.  

I pulled and resoldered the pins. Now everything is fine. 

Ignacy, NO9E



--
Sent from: http://elecraft.365791.n2.nabble.com/