[Elecraft] setting up digital on k3

[Don Wilhelm]

Robert,

There are 4 data submodes in the K3.  DATA A is for soundcard digital 
and is the default sideband same as USB except that compression is 
turned off and any Equalizer settings you might have for SSB are set to 
flat.

AFSK A is specifically set with defaults for RTTY from a soundcard - 
default sidenamd is LSB.

PSK D (direct) can be used for PSK31 or PSK63 if you use the KY commands 
to send ASCII to the K3 or you can key from the paddles with CW and they 
will be sent as PSK.

FSK D is similar to PSK D, but you can also use the FSK IN pin in the 
ACC connector to send FSK driven RTTY.

73,
Don W3FPR

On 10/20/2017 1:10 PM, Robert . wrote:
> For ft8 jt65
> Mode must be USB
> 
> Data modes on k3 are setup for rtty
> Best I recall
> 
> 73 Robert W5AJ
>