[Elecraft] Problem saving PX3 configuration

[Dave Sublette]

Good Morning Bob,

I’m not sure my problem is the same as yours.  My PX3 is only 2 years old and I had never saved a configuration file to this point.  Neither had I adjusted the amplitude and phase on the I and Q channels.  I did that for the first time last night and, seeing it was recommended procedure, attempted to save the configuration.  That is when I had the problem.

When the support folks at Elecraft have had their morning coffee, I will call and see what they have to say.

Thanks for thinking along with me.

73,

Dave, K4TO
> On Oct 17, 2017, at 9:05 AM, Bob N3MNT <bob at hogbytes.com> wrote:
> 
> There was an issue with saving and recalling the configuration and memory
> settings with the PX3 but I do not recall ever seeing a firmware update to
> fix.  The issue was during the last update, there was an oversight.  The
> file name for file was changed in one section of the code, but not in
> another causing an error.  This was some time ago so I will have to go back
> and look at my solution. But it essentially meant that you saved the file
> under the new naming convention, then had to change the name to the old
> convention and you could recall it.  
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k4to at arrl.net