[Elecraft] P3 not showing anything

[Andrew Holman]

Thanks Don, I decided to take a look again at the inside of the radio.
Re-seated all the cards and then took the bottom off. Guess what, that
single cable that attaches to the bottom of the board was disconnected,
probably from when I was putting the filter in.  I connected that up and
all is right with the world again.

Thanks for all the help and always remember to check that cable on the
bottom of the radio :)

On Sun, Oct 15, 2017 at 5:31 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:

> Andy,
>
> Do you have another receiver?  If so, connect it to the K3 IF OUT.  If you
> hear signals, then the K3 is working fine, look at the P3 for the problem.
>
> OTOH, if you do not hear signals, review the work you have done - was a
> cable left unplugged inside the K3 or other "silly" stuff like that.
>
> The IF takeoff is before the roofing filters, but the BPF3 is before the
> IF takeoff.  Check your work with the KBPF3 installation.
>
> 73,
> Don W3FPR
>
>
> On 10/15/2017 5:16 PM, NB8F wrote:
>
>> NOTE I have also tried removing everything in-line and just having the
>> antenna, radio and P3 connected.
>>
>> I also tried removing the new board, but I did not try removing the 6khz
>> filter. This all worked fine before today.
>>
>


-- 
------------------
NB8F
Andy Holman