[Elecraft] P3 not showing anything

[Ian Kahn]

Andy,

This may be a dumb question, but did you reconnect your antenna feed line?
I can't tell you how many times I've made that mistake. :-)

73 de,

Ian, KM4IK

On Oct 15, 2017 3:51 PM, "NB8F" <nb8f at nb8f.com> wrote:

> Today I went about upgrading my K3S with the KBPF3 board and a 6khz filter.
> I moved all my filters down one slot and put the 6khz filter in the first
> slot. I installed the KBPF3 board, turned it on in the config etc.
>
> I then went to the K3 utility and configured my filters, all seemed to go
> well.
>
> I turned the radio on after connecting all the cables and the pan adapter
> does not show any signals. It is getting frequency information and changes
> as I move the dial.
>
> I have the cable connected into IF OUT on the radio and IF IN on the P3,
> and
> I have tried both of the serial cables that came with the radio.
>
> Connection to the computer works, the radio itself boots with no errors,
> but
> nothing shows on the panadapter.
>
> See video attached for any help.
> https://youtu.be/Md3ILmdJLDI
>
> Thanks in advance for any help.
>
> Andy (NB8F)
>
>
>
> -----
> NB8F - Andy
> Elecraft K3S - #11282 / KX2 - #1791
> Elecraft owner since June 2017
> Ham since March 2015
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to km4ik.ian at gmail.com
>