[Elecraft] Key Out jack

[Jim Rhodes]

There is however an adjustable delay. Default 8 ms, which can be adjusted
with TX DLY in the CONFIG menu.

On Fri, Oct 13, 2017 at 5:21 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:

> Skip,
>
> Yes, it does follow the keying when in QSK.  If it did not, the KPA500
> would not follow the K3(s) in QSK mode (the KPA500 connection uses the
> KEYOUT-LP from the ACC connector).
> The T/R switching is all electronic and can be quite fast.
>
> If the amplifier uses relay switching, the relay may not be able to follow
> the K3(S).
>
> 73,
> Don W3FPR
>
> On 10/13/2017 6:02 PM, Fred Jensen wrote:
>
>> Related question:  Does KEY OUT essentially follow the TX state?  IAW, if
>> PTT or VOX is asserted, it also asserts?  If so, I guess that means that it
>> follows the keying when in QSK?  It's a real PITA to get to the back of my
>> K3 right now or I'd check it myself.
>>
>> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jimk0xu at gmail.com
>



-- 
Jim K0XU
jim at rhodesend.net