[Elecraft] K3 after turning on doesn't receive or transmit

[Ron D'Eau Claire]

Yes! Like most equipment these days, the K3 needs to do an orderly shutdown under control of its processor to turn off safely and reliably. Like your P.C. you can pull power unexpectedly and it will often recover okay when power is reapplied, but you can also get corrupted data that forces a firmware reload - perhaps even using the forced MCU load procedure in the Owner's manual - as well as discovering that it turns on in an unexpected state or that it has "forgotten" certain parameters you set when it was last used. 

73, Ron AC7AC


-----Original Message-----
From: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dave Cole (NK7Z)
Sent: Friday, October 13, 2017 1:00 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 after turning on doesn't receive or transmit

Respectfully, is that really true?  The K3 needs to be shutdown via the Power switch due to some sort of shutdown procedure, (or internal timings issue), within the radio?

73s and thanks,
Dave
NK7Z
http://www.nk7z.net