[Elecraft] K3S and P3 pinout/cable stuff... (How to drive yourself mad integrating an SPE amp into your system)

[Clay Autery]

Doh!  Thanks Lyle...  I was unaware that the K3S schematics had finally 
been put up for download...

______________________
Clay Autery, KY5G
MONTAC Enterprises
(318) 518-1389

On 10/12/2017 2:48 PM, Lyle Johnson wrote:
> Clay,
>
> Go to the Elecraft website, then go to the manuals section, then 
> download the K3S schematics, then go to the KIO3B Digital I/O Module 
> page.  You'll find two boxes with pin definitions for the connector in 
> question.  And of course the K3S schematic set will allow you to 
> follow them as deeply into the radio as you'd like, perhaps deeper :-)
>
> 73,
>
> Lyle KK7P
>
> On 10/12/17 12:25 PM, Clay Autery wrote:
>> ...
>> Can someone give me a DEFINITIVE pinout for ALL 8 pins on the K3S' 
>> RS232/P3 Port?
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ky5g at montac.com