[Elecraft] K3s rear mic connector and shure SM58.

[Bob McGraw K4TAX]

Joe.    He is using the rear panel MIC input.  It is unbalanced. 

Bob, K4TAX


Sent from my iPhone

> On Oct 6, 2017, at 7:50 AM, Joe Subich, W4TV <lists at subich.com> wrote:
> 
> 
> > Pin #1 & #3 to ground
> 
> Pins 1 and 3 should *never be tied together*.  If your transceiver has
> a balanced input *or* a *separate* case/chassis connection, connect
> pin 1 (shield/mic case) to the case/chassis connection (ideally to the
> *shell* of a Foster mic jack that is bolted securely to the metal case
> of the transceiver).
> 
> If your transceiver does not have a separate case/chassis connection
> (the K3/K3S rear mic jack *does not*) leave pin 1 disconnected
> (floating).
> 
> 73,
> 
>   ... Joe, W4TV
> 
> 
>> On 10/5/2017 9:30 PM, Bob McGraw K4TAX wrote:
>> No preamp required.  Set the Mike gain via the menu to high. Easy to wire the mike XLR to an unbalanced circuit.   Pin #1 & #3 to ground and Pin #2 to MIC high.  See page 55  of the manual [MIC SEL] for details.
>> If you close talk the mike it will be bottom end heavy. Typically no closer than 4" will be OK.  Move in closer and the bottom end comes up, back away and the bottom end falls off. This is due to the proximity effect of they type dynamic mike.
>> Otherwise, they sound quite good/.
>> 73
>> Bob, K4TAX
>>> On 10/3/2017 1:50 PM, Stewart wrote:
>>> Is anyone using a Shure SM58 mic with their K3s? If so are you using a preamp? My O'scope shows that the mic and cable are good but level is pretty low.
>>> 
>>> I don't get anything with the mic connected to the rear mic jack. Config is set to rp l , bias off. I tried mic gain from 0 - 100.
>>> 
>>> K3s is new so I may be missing some menu item.
>>> 
>>> Regards,
>>> 
>>> Stew ke4yh
>>> 
>>> 
>>> 
>>> ---
>>> This email has been checked for viruses by AVG.
>>> http://www.avg.com
>>> 
>>> ______________________________________________________________
>>> Elecraft mailing list
>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>>> Help: http://mailman.qth.net/mmfaq.htm
>>> Post: mailto:Elecraft at mailman.qth.net
>>> 
>>> This list hosted by: http://www.qsl.net
>>> Please help support this email list: http://www.qsl.net/donate.html
>>> Message delivered to rmcgraw at blomand.net
>>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to lists at subich.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net