[Elecraft] Antenna 2

[Bob McGraw K4TAX]

Either put a small 50 ohm load or leave it open.  A short to ground may cause a PA device failure. 

Bob, K4TAX


Sent from my iPhone

> On Nov 28, 2017, at 5:19 PM, Jim Rhodes <jimk0xu at gmail.com> wrote:
> 
> Well if you accidentally transmit into it an open might be better than a
> short. Did you at least disable it using the utility program?
> 
> Jim Rhodes
> K0XU
> 
>> On Nov 28, 2017 16:52, "Paul Ormandy" <paulzl4tt at gmail.com> wrote:
>> 
>> Thanks for the replies. Hadn't thought of its use for sub rx or dummy load.
>> I have grounded out the connector with a plug hooked directly to the
>> receiver grounding terminal.
>> 
>> Paul
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to jimk0xu at gmail.com
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>