[Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle

[MaverickNH]

I have always had problems using the K3 Utility to change configurations from
another mode to CW, as I could see text decode on the K3S VFO B display area
after a restore to my CW configuration but not on the P3-SVGA external
display without a lot of fiddling. I see now that simply turning the P3
on/off is required after a configuration restore to get that text decode to
display.

I would make a note of that but would just forget where I put it. Now, it's
right here for me to find!

Bret/N4SRN



--
Sent from: http://elecraft.365791.n2.nabble.com/