[Elecraft] ATU TUNE does not work in DATA A Split mode

[Nr4c]

What mode and frequency on VFO B AND VFO A when this occurs? 

Sent from my iPhone
...nr4c. bill


> On Nov 16, 2017, at 3:50 AM, Michael Eberle <mteberle at mchsi.com> wrote:
> 
> Was this issue ever resolved?  I have noticed the same thing with mine
> although the issue does not appear to be the tuner itself, but the K3 is not
> transmitting any power so the tuner has nothing to work with.  I am running
> FW version 5.60 an have this issue but only on 6 Meters.
> 
> I can power up the K3 and open WSJT-X on my computer and select 6 meters
> which usually causes SPLIT to turn on.  Hold TUNE and the TX keys and the
> display shows 0 power.  Turn off SPLIT and it puts out power as usual.  Then
> if I turn SPLIT back on, it will then output a carrier as usual.  
> 
> If SPLIT is enabled on 6 meters and you run a TX gain calibration, it will
> fail the calibration because the TX puts out no power.
> 
> It's not a major issue but an annoyance since I tend to forget about it
> every time I switch from HF to 6 and try to check my antenna tuning.
> 
> Thanks,
> Mike, KI0HA
> 
> 
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com