[Elecraft] K1 - VFO frequency range

[Don Wilhelm]

Roney,

There is no adjustment for individual bands.

If you have no other band boards, you can adjust the turns on L1 to 
bring the lower end of 80 meters up to 3.500 MHz.

Normally, the VFO range is adjusted so that all bands will tune a bit 
below the low frequency limit.  This compensates for slight variation of 
the exact frequency of the crystal on the band board.

If you have multiple band boards, check to see which band is closest to 
the lower ham band and adjust the turns spacing of L1 to bring that band 
near the lower edge of the band.

73,
Don W3FPR

On 5/24/2017 8:52 AM, roney wrote:

> 
> So I did Band Assignments (Page 39), etc, etc.
> 
> When seeing each band, my real ranges are:
> 
> 80m: 3.493,8   to  3.577,6 mhz
> 15m: 20.990,9 to 21.074,6 mhz
> 
> I did not understand how to adjust these low and high limits. Should I
> change some inductor turns ? or is there any menu adjust for these limits ?