[Elecraft] K2/100 overheating?

[Don Wilhelm]

George,

I will check the fan air flow direction tomorrow because I am uncertain.
If you have the label out and the wires on the correct holes, yours is 
likely OK.

There are 2 philosophies about the fan direction.  One is that you 
should exhaust the heat and let the assembly draw cool air across the 
hot components.

The other says to let the fan "blow" on the hot components.
The major difference between the two is that a blower fan adds heat to 
the air (due to the work produced by the fan), but adds the benefit of 
directing the air flow to the area to be cooled.
An exhaust fan does not add its work product heat to the air being 
moved, but the cool air cannot be directed as well because it is spread 
over a large area in the enclosure box.

73,
Don W3FPR

On 5/21/2017 11:26 AM, George Winship, NC5G wrote:
> Interesting. I built my K2/100 about 17 years ago and the fan has always
> drawn air into the cabinet and exhausted over the heatsink. So, I rechecked
> the manual and disassembled my rig to check for proper assembly. Fan label
> is facing out and wires are soldered to the right pads(red=+, black=-). Was
> there maybe a change in later models?
> 
> 73, George
> 
> 
> 
> Make certain the fan is mounted with the label out and that the red wire
> is in the +hole and the black one in the -hole.
> The fan should exhaust the hot air.  Cooler air flows in at the front of
> the heatsink.
> 
> 
> 
> 
> 
> 
> 
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/K2-100-overheating-tp7630828p7630883.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>