[Elecraft] Dual -Watch and KRX3A sub-receiver install in a K3s

[Nr4c]

Yes. The DSP board for the sub-rec is installed on the front panel. I too used to dread removing the panel but after the second time, it's no big deal. It is just a case of being careful when re-assembling. 

Sent from my iPhone
...nr4c. bill


On May 12, 2017, at 8:34 AM, Irwin Darack <idarack at gmail.com> wrote:

>> From everyone's comments, I realize that to have dual watch ( listen to two
> different frequency on the same band) on my K3s, I need to install the KRX3A
> sub-receiver. I have two K3s that I have built, one with the KRX3A and the
> second without. I am thinking of upgrading the second one with the
> sub-receiver now.
> 
> To install a KRX3A in an already built K3s do I need to remove the front
> panel? I am hoping that I do not as to reinstall the front panel you have
> to be very careful not to bend a pin. I realize that I have to install some
> new additional stand-offs on the main RF board. I have reviewed the KRX3A
> install instructions and it's a little confusing on the difference in a
> older K3 versus a K3s. It appears that you have to take the front panel
> totally apart?
> 
> Looking forward to see everyone at Dayton (Xenia).
> 
> Thanks, Irwin KD3TB
> -- 
> Irwin KD3TB
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com