[Elecraft] Remoting the KPA500 & KAT500?

[Ken K6MR]

My “Aux” cable is about 25 feet long. It’s just a CAT5 cable wired appropriately.  Works fine.

Ken K6MR

From: Harry Yingst via Elecraft<mailto:elecraft at mailman.qth.net>
Sent: Friday, May 5, 2017 9:38 AM
To: Michael Walker<mailto:va3mw at portcredit.net>
Cc: elecraft at mailman.qth.net<mailto:elecraft at mailman.qth.net>
Subject: Re: [Elecraft] Remoting the KPA500 & KAT500?

Thank you
The USB cable will be under 15 feet as the room I'm moving it to a finished storeroom inmy basement is directly below me. I could run serial but the USB makes for a easier install.
One advantage of the move will be easy access to run a new 220 to that room
The one thing I forgot about is the 15 pin aux cable but at that length it will probably be OK.





      From: Michael Walker <va3mw at portcredit.net>
 To: Harry Yingst <hlyingst at yahoo.com>
Cc: "elecraft at mailman.qth.net" <elecraft at mailman.qth.net>
 Sent: Friday, May 5, 2017 8:06 AM
 Subject: Re: [Elecraft] Remoting the KPA500 & KAT500?

Hi Harry
You have 2 ways to do this and extending USB is not the best choice if it would work at all.
Depending on how far the run is, it might be able to do it via RS232 (from your USB connector) direct into back of devices.  While the spec for RS232 is about 20ft or less, I currently run RS232 over 120' at 9600 baud.  That is fast enough for these devices.  You don't need to go to 38,400 baud as that will limit your cable length.
This is what I do on my remote base for my Steppir and Rotator control and the tower is 120ft away from the computers.  I don't use any tuners, as that is one less thing to worry about.  None of my equipment is heated and I have seen it work down to -30C without issue.
Your other option is to run a LAN cable and use RS232 over IP adapters such as https://www.amazon.com/USR-TCP232-306-Serial-Ethernet-Converter-RS232/dp/B01MXWACF3/ref=sr_1_8?ie=UTF8&qid=1493985728&sr=8-8&keywords=rs232+lan.  The guys are RS485.com have some cool stuff as well.  www.rs485.com<http://www.rs485.com>
You run some software in your computer that will run the Elecraft software.  From Elecrafts perspective, it looks like a normal serial port.  On the other end the KPA500 plugs into the device above.
One last option is to use RS422 boxes that extend RS232 for miles.
Don't forget, you will need good AC power installed.  If you can, I would recommend using 220V and not 115V as that will limit your voltage drop.
I hope that helps
Mike va3mw





______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k6mr at outlook.com