[Elecraft] KX3 firmware request - separate internal/external power supply settings

[Thorpe, Jeffrey]

Right now there is just the "Bat Min" setting that gives an alarm if the present voltage drops to a set value in the configuration menu. (Automatic shutdown happens at 7.0V according to the manual.) I use an external LiFePO4, and internal NiMH. These have different specs. I would like to see more configuration options that allow me to "disconnect" the external LiFePO4 when it reaches a certain voltage (10V) and then switch to the internal NiMH which may be (and likely are, at least in short order) at a lower voltage than the external. I would also like to be able to have the ability to make the auto-shutdown happen at a higher voltage than 7.0V (8.0V in this case.)

Under the current setup, power is supplied by the higher voltage supply, which can result in a ruined external battery (if the internal protection circuitry of the battery should fail) as the power supply would flip-flop between the two. I would like to have a little bit more control. Maybe that's just a personality defect.

Jeff - KG7HDZ