[Elecraft] FW: K3s Wattmeter

[Augie "Gus" Hansen]

On 3/25/2017 7:36 AM, efortner wrote:
> ...
>
> WMTR HP. The power control will not go past 12 watts. The auto calibration
> works fine on 5 watts but when finished next takes me to the 1 milliwatt cal
> instead of 50 watts. Following directions to set power to 50 watts does not
> work.
>
> Any suggestions. I really do not want to send it back to Elecraft if I can
> get it going. I have the latest firmware.

Check to see that the KPA3 menu item is set to PA NOR. Given that other 
config items got changed, this one could be in bypass or some other setting.

Gus Hansen
KB0YH