[Elecraft] K2 main encoder wanted

[Bob G3PJT]

Yes the shaft is very slightly bent

73 Bob G3PJT


On 23/03/2017 09:51, Vic Rosenthal 4X6GP wrote:
> Are you certain that a bit of fiber from the felt washer hasn't worked 
> its way between the shaft and the bushing? That is a known problem.
> 73,
> Vic, 4X6GP
> Rehovot, Israel
> Formerly K2VCO
> http://www.qsl.net/k2vco/
> On 23 Mar 2017 11:41, Bob G3PJT wrote:
>> Hi Don
>>
>> Thanks for the reply. I did know about the new encoder kit but the 
>> problem is that of its cost when it gets here.
>>
>> Elecraft quote 124USD for the kit, that's £100 here which then gets 
>> VAT at 20% and a local handling charge - say a total of £130-140 and 
>> as well if I read things correctly I will need to get a new knob.
>>
>> So you can see that my problem is that unless I can get a cheaper 
>> replacement I might as well sell the K2/100 either in bits for spares 
>> or at a discount.
>>
>> The encoder does work fine but it has suffered a knock which has made 
>> it slightly stiff to turn, i.e it wont 'spin', but it is useable.
>>
>> So thanks for the thoughts
>>
>> 73 Bob G3PJT
>>
>>
>>
>>
>