[Elecraft] KX3 Extended Temperature Compensation Procedure - cannot start data collection

[Oliver Barrett]

Hi all,

I successfully executed the steps in the KX3 Extended VFO Temperature Compensation Procedure, down to where PITCH was pressed to show the temperature compensation display (after the KX3 had been retrieved from the refrigerator, turned on and REF CAL was unlocked).


The temp. and freq. parameters were shown as expected, but when I tapped APF twice to start the data collection, nothing happened [SAVING did not appear on VFO B].  The prior Initial Reference Calibration procedure worked fine.


What might I be doing wrong?


Thanks!

Oliver Barrett  KB6BA