[Elecraft] KX2 pins

[Matt Zilmer]

Just so we're all using the same terms ...

The KX2's "front" is the control panel, and its bottom cover is where 
the speaker is located.  The factory programming header is located below 
the sheet metal surface away from the op, which some may choose to call 
the back for that reason.

Confused?  Spatial orientation is one of the more difficult thinking for 
us mere humans to deal with, especially if you have to assign a label to 
a surface.  Words never seem to suffice.

Anyway, don't mess with the factory programming header.  Someone on this 
thread got that right.

73,

matt W6NIA

KX2 Program Manager


On 3/19/2017 5:52 PM, Emory Schley wrote:
> You guys keep referring to pins on the back of the KX2. I looked and looked and then looked some more. Either I have a defective unit or I must be going blind. There are NO pins on the back of my KX2... Perhaps you guys are talking about the pin connector on the TOP side of the radio? I've got some there, but no connectors on the "back".
>   
> Emory Schley
> N4LP
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to mzilmer at roadrunner.com

-- 
Matt Zilmer, W6NIA
www.elecraft.com
Office: 831-763-4211 x125
Mobile: 909-730-6552
[Shiraz]