[Elecraft] Fldigi and K3S

[Barry]

Carl,
     I just went through a version of that. I had no problem getting 
FLDIGI to work with my K3s, but it would not work over N1MM. What I 
finally discovered is that I had to go into N1MM's config tab under 
hardware and needed to set PTT to on. It makes no sense as I use VOX to 
do the same thing and it worked with VOX natively. Until I fixed it, I 
had no problem with using MMTTY as my RTTY interface. Now, I can go back 
to FLDIGI. There's a bug in there, but I'm not sure whether it's FLDIGI 
or N1MM+

73,
Barry
K3NDM



------ Original Message ------
From: "Carl Yaffey1" <cyaffey at gmail.com>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: 3/18/2017 9:12:17 PM
Subject: [Elecraft] Fldigi and K3S

>Trying to get Fldigi working with my K3S. Had it working fine with my 
>K3.
>No problem receiving PSK. But clicking T/R doesn’t start up the 
>transmitter. I’ve tried all sorts of different settings in the rig 
>control, modem, sound card, etc. No luck.
>Any suggestions?
>73,
>Carl Yaffey  K8NU
>http://www.carl-yaffey.com
>http://www.grassahol.com
>http://www.bluesswing.com
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to k3ndm at comcast.net