[Elecraft] Power Supply for K3s/10

[Don Wilhelm]

Nick,

I would think the PAE Kx33 supply would power the K3/10 nicely.  You 
would have to change the power connector to APP.
Now then, if you have any accessories connected to the K3 12 volt 
output, you may need more current than the Px33 can deliver.

I normally recommend a 6 amp supply for K3 users only because they 
usually have other accessories that are also connected to the power source.

The Kx33 is very good about RFI in the ham bands, and with my cautions 
about adding accessories to the total load, it should serve you and your 
K3/10 just fine.

Maybe you need two of them - one to power the K3/10 and another to power 
the shack accessories.

73,
Don W3FPR

On 3/18/2017 11:39 AM, Nick - VE3EY wrote:
> I am looking for recommendation about what power supply can I use with
> K3s/10 (10 watt only). The rig does not have the KPA3 brick installed.
>
> This will be primarily a travelling rig and the weight + size is the reason
> I would like to have a small switching but RFI free power supply.
>
> I have SS30 DV and other 30A switching PSUs but they are obviously overkill
> for this type of rig.
>