[Elecraft] bricked my K3

[Dick Dievendorff]

Jamie:
First install the most recent version of the K3 Utility from our web page at http://www.elecraft.com/K3/k3_software.htm.  It's verison 1.16.7.25.

There are step-by-step instructions in K3 Utility Help, troubleshooting, MCU load failure, that will walk you through the recovery steps.

73 de Dick, K6KR



-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jamie WW3S
Sent: Saturday, March 18, 2017 08:29
To: elecraft at mailman.qth.net
Subject: [Elecraft] bricked my K3

trying to load new firmware......if I read Fred manual correctly, power on while holding “SHIFT/LO/0” should reset it but its not working......the SHIFT/LO/0 is that the knob for the width? I’m assuming it is, but mine doesn’t say the zero.....
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to dick at elecraft.com