[Elecraft] KX3 Utility - "KX3 is not responding"

[Don Wilhelm]

Jeff,

Dropping the baud rate is not likely to solve the problem.
For the firmware download, KX3 Utility sets the KX3 baud rate to 38400 
automatically.

I suspect you had a driver issue in your computer that was corrected by 
the update.

73,
Don W3FPR

On 3/12/2017 4:41 PM, Jeff Hughes wrote:
> FYI, Rich… Aye, my KX3 is new, fresh from the mothership.  If I encounter this problem again I’ll try dropping the baud rate.