[Elecraft] VOX/PTT select macro ?

[Bob Wilson, N6TV]

The VX; command (GET only) will return the current state (VOX ON or OFF =
PTT).

*Note:*  there is an error in the documentation in the K3 Programmer's
Reference
<http://www.elecraft.com/manual/K3S&K3&KX3&KX2%20Pgmrs%20Ref,%20F8.pdf>,
which says:

"RSP format: VXn; where n is 0 (VOX on) or 1 (VOX off)."

(sic)


But the observed responses are quite the opposite, and far more intuitive:

VX0;  VOX is OFF
VX1;  VOX is ON


The current Programmer's Reference still says "A SET version of the command
is planned."  But I suppose those plans are not very high on the priority
list.

73,
Bob, N6TV

On Sat, Mar 11, 2017 at 8:29 AM, K5MWR via Elecraft <
elecraft at mailman.qth.net> wrote:

> At one point in the macro command reference there was a statement that
> VOX/PTT selection would be available through a direct macro command.
> Currently all I am able to make work is the SWT or SWH type command which
> is basically of no use since there is no way to know what the current mode
> is.  Has anyone found a work-around for this?
> Thanks
> Dave K5MWR
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6tv at arrl.net
>