[Elecraft] OT: 2017 Chevy Silverado 1500 power outlets

[Alan]

I once had the connection to the battery on my old VW bug fail due to 
corrosion around the battery contacts.  I don't remember if it was the 
positive or negative lead.

I believe modern autos often have a current sensor in the negative 
battery lead.  So you are supposed to connect the radio negative lead to 
the chassis side of the sensor.  And if you connect it to any part of 
the negative battery lead you should fuse it in case the battery chassis 
connection goes bad for any reason.

Alan N1AL


On 06/27/2017 12:42 PM, Charlie T, K3ICH wrote:
> I have to ask, has ANYONE ever heard of a circumstance where the negative
> return lead from the battery to the engine block has ever failed, short of a
> battlefield situation?
> Still, probably a good idea to fuse the negative to radio wire anyway.
> 
> Charlie k3ICH
> 
> 
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Vic Rosenthal
> Sent: Tuesday, June 27, 2017 11:52 AM
> To: Clay Autery <KY5G at montac.com>
> Cc: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] OT: 2017 Chevy Silverado 1500 power outlets
> 
> I don't think math or difficult physics is needed. Suppose you connect the
> radio directly to battery, and then suppose the battery to ground cable
> becomes partially or completely disconnected. Finally, suppose you then try
> to start the engine. When the starter solenoid closes, some of the high
> current from the battery negative terminal flows through the negative lead
> to the radio, and then to ground through the radio's mounting bracket, the
> coax to the antenna, etc. The no. 10 ground wire might have to carry several
> hundred amps! Lots of things can be damaged.
> This is why negative leads should be fused, at least.
> 
> Vic 4X6GP
> 
>> On 27 Jun 2017, at 18:21, Clay Autery <KY5G at montac.com> wrote:
>>
>> Horse puckey!  I DEFY you to prove the physics OR math of that
>> ridiculous statement.
>>
>> ______________________
>> Clay Autery, KY5G
>>
>>> On 6/27/2017 9:55 AM, donovanf at starpower.net wrote:
>>> WARNING!
>>>
>>>
>>> For extremely important safety and fire prevention reasons reasons,
>>> no accessory should ever be connected directly to the negative
>>> terminal of an automotive battery . Just like when charging an
>>> automotive battery, the negative lead of a cable running directly to
>>> the battery should always connect to the engine block and never
>>> directly to the battery.
>>>
>>>
>>> The positive lead must be fused where it connects to the battery.
>>>
>>>
>>> There's an excellent discussion here:
>>>
>>> https://www.w8ji.com/negative_lead_to_battery.htm
>>>
>>>
>>> 73
>>> Frank
>>> W3LPL
>>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html Message
> delivered to pincon at erols.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>