[Elecraft] k2 and kpa 100

[Don Wilhelm]

Christophe,

That is the modification I thought you were referring to.

If your K2 serial number is 3000 or higher, that mod is already 
installed, and you do NOT have to do it.
Notice that it refers to the REV A RF board.  Rev B boards are used in 
K2s with a serial number of 3000 or more.
Also if your K2 is serial number 3000 or more, when you get to page 59, 
you should not do the Control Board wiring changes shown there.  Those 
changes have already been embedded on the REV B board.

Yes, an infinity reading is good at the AF pad on the KPA100 board.  See 
the "I triangle" note near the top of the 2nd column on page 22.

73,
Don W3FPR

On 6/27/2017 9:31 AM, Christophe F8ACF-56 wrote:
> Hello Don,
>
> It does not matter to your Frenchman, my Englishman and far from being 
> the one you master!
>
> I use google translation HI! To try to make me understand as well as 
> possible
>
> For mounting the KPA 100 I arrived on page 22, "initial test" 
> everything is OK
>
> But I have a doubt about "AF pad", ground.
>
> The measure gives infinity is this correct?
>
>
>
>