[Elecraft] K3+P3+Microkeyer II

[Josh]

Patch the OM Power between P3 and microham box. TCVR goes to P3 and PC goes to microham. Then select Elecraft and baud rate from the menu. You should immediately see it following frequency on the display. 

OM Power echoes serial commands through and monitors the data. I don't have your model, but this is how they all work. 

Any problems you should contact OM Power support. Tibi is very good and will respond quickly. 

73,
Josh W6XU

Sent from my mobile device

> On Jun 18, 2017, at 2:45 AM, Natale Borghetti <nborghetti at alice.it> wrote:
> 
> I have installed K3+P3+Microkeyer II and as result I have all the com ports busy.....now I am setting up the OM-POwer 2000A+ amplifier and in order to have the automatic tuning I have to supply the RTX frequency......how can I do it ???
> 
> Some say to me...using the CI-V Icom interface of the Microkeyer II...but what to set in the amplifier ??
> 
> Some say just install a Y cable at the output of RTX rs232
> 
> Just to give an idea of my wiring:
> 
> K3 rs232 go to P3 DB9 Labelled XCVR
> 
> Microkeyer rs232 go to P3 Labelled PC
> 
> 
> I am missing some thing ???
> 
> Hoping on some help and advice
> 
> 
> 73 and DX
> 
> 
> 
> -- 
> Natale Borghetti
> 
> I5NPH
> 
> nborghetti at alice.it
> 
> -- 
> Natale Borghetti
> 
> I5NPH
> 
> nborghetti at alice.it
> 
> 
> 
> ---
> Questa email è stata esaminata alla ricerca di virus da AVG.
> http://www.avg.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to josh at voodoolab.com