[Elecraft] K3+P3+Microkeyer II

[Joe Subich, W4TV]

Don is off base when he talks about a system using a microHAM
product.  Configure your station as shown in the application note
"Using the Icom PW-1"
   <http://microham-usa.com/store/cmspage.php?page_id=27>
at http://www.microHAM-USA.com/support.html

The connection diagram for microKEYER II is here:
   <http://www.microham-usa.com/appnotes/MK_II_PW-1.pdf>

You simply configure the amplifier as if it was connected to
an Icom transceiver - that information is generally in the
instruction manual provided by the amplifier manufacturer.

Note: this information applies to *any* frequency agile amplifier
capable of serial control using Icom protocol.  The information
in the application note "Using the Icom PW-1"
   <http://microham-usa.com/store/cmspage.php?page_id=27>
also covers interfacing of BCD controlled amplifiers - like the
Yaesu FL-7000/Quadra, Elecraft KPA500 (and KPA1500), Ameritron
ALS-600/1300/1306, etc. to transceivers which lack BCD outputs
using microHAM Station Master.

73,

    ... Joe, W4TV


On 6/18/2017 6:53 AM, Don Wilhelm wrote:
> Natale,
> 
> Put the "Y" cable at the PC connector on the P3.
> As far as how to set your amplifier, I leave that to others familiar 
> with that amp to answer.
> 
> 73,
> Don W3FPR
> 
> On 6/18/2017 5:45 AM, Natale Borghetti wrote:
>> I have installed K3+P3+Microkeyer II and as result I have all the com 
>> ports busy.....now I am setting up the OM-POwer 2000A+ amplifier and 
>> in order to have the automatic tuning I have to supply the RTX 
>> frequency......how can I do it ???
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>