[Elecraft] K-Pod software 1.09

[Don Wilhelm]

Art,

Yes, the K-Pod knob moves at 1/2 the rate of the K3 VFO knob.  It is 
intended to be that way.

The software does not change that relationship.  There were counts being 
lost between the K-Pod and the K3.  That was what the buffer fixed.

73,
Don W3FPR

On 6/17/2017 11:21 AM, Art via Elecraft wrote:
> The description of the update states ":Changes encoder operation to allow the K-Pod to buffer encoder counts to the K3. This helps the K3 and K-Pod remain in sync."
> 
> 
> However, that's not my experience. I have the VFO set to 200 CTS, so the K-Pod should match it after this update. However, the K-Pod only moves 100 CTS-exactly half of what the main VFO moves. Tried going to 400 CTS on the main VFO. K-Pod then moves 200 CTS.