[Elecraft] [KX3] HI CUR error with 2m module

[Don Wilhelm]

Steve,

Do you have a dummy load that is good up through 148MHz?
If so, Connect it and see if you get the same error.
If not, investigate your antenna and feedline.
If it is still present, contact K3support.

73,
Don W3FPR

On 6/10/2017 8:08 PM, Steve Ward wrote:
> I'm pretty sure I've seen something about this before.  I just got my 
> KX3-2M that I ordered at Sea-Pac, and installed it in my radio tonight. 
> Everything seems OK except when I try to transmit I get a HI CUR error 
> unless I keep output power below 1.2 watts.  I'm running from a 35A 
> linear PS so supply isn't the issue...
> 
> The only thing I saw in the archive was a mention about a loose SMA 
> connector, but everything looks OK in that respect.  Any thoughts?
> 
> Thanks,
> 
> Steve
> AD7OG
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>