[Elecraft] PR6 Preamplifier Power Plug 'P1'?

[Joe Subich, W4TV]

P1 is a three pin 0.1" spacing PC "Header" type plug (rectangular body -
no lip).  The plug housing is 0.30" W x 0.10 T x 0.60" L.

I do not know the manufacturer/part number.

73,

    ... Joe, W4TV


On 6/4/2017 10:07 AM, Nr4c wrote:
> I'd bet on coaxial power connector as used on other Elecraft gear.   A 5 X 2.1 mm.
> 
> 
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On Jun 3, 2017, at 10:22 PM, Jeffrey Maass <jmaass at k8nd.com> wrote:
>>
>> What is the manufacturer / type of the 'P1' plug required to provide power
>> to the PR6 preamplifier?
>>
>>
>>
>> I cannot find any note in the manual or in previous posts to this reflector.
>>
>>
>>
>> Thanks / 73,
>>
>> Jeff K8ND
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nr4c at widomaker.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>