[Elecraft] Query, KPA500 Remote Opns

[Michael Walker]

Hi Jack

I do use my 6300 with the KPA500 and have done so for over 2 years.

The way I do it is with a local pc at the remote.

The other way for you would be to install a serial to ip converted at your
remote and then run the KPA500 software at home.  In the configuration of
the Serial To IP converter this will work.

The RemoteQTH Server has most of this built in as well and then you can
expand to control more items.

Mike va3mw


On Fri, Jul 28, 2017 at 1:49 PM, k5aj at gmx.com <k5aj at gmx.com> wrote:

> Hello,
> This is my 2nd attempt to get this into the digest.
> Is there a way to remotely cause the KPA500 to switch
> between OPERATE and STANDBY?
>
> With the new Flex 2.0 Software, the entire flex
> radio can be operated over IP.  Ultimately, there
> ought to be a way to allow the KPA500 to switch Standby/Operate
> over IP in tandem with the Flex SDR 2.0 software.
>
> Next question, and this may be too hard to do.  Is there a
> way for a remote operator to ascertain the KPA500's SWR/Pwr
> remotely over IP, so I won't have to beam an IP camera to the
> Elecraft front panel?
>
> Thanks much,
> Jack
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to va3mw at portcredit.net
>