[Elecraft] KX3 (SN01674) and CW in SSB - Feature request

[Don Wilhelm]

Martin,

Yes, the CW memories will not work well with CW in SSB.
Input from the paddles or hand key should work fine.

If you must use the CW memories, you must switch to CW mode and set the 
frequency above or below the SSB frequency.  Perhaps a macro could be 
created to do that with one button push, and another to go back to SSB.

73,
Don W3FPR

On 7/27/2017 8:39 AM, Martin Theodor Grewe wrote:
> Hi Don,
>
> thanks for your answer ​and Explanation. CW WGHT is known but not 
> helpful in this case.
>
> I'll try to explan: CW WGHT is set to 800Hz. I'am operating in USB, 
> using CW-In-SSB. I can answer the station.
> But station cannot read my signal, I try to answer with an stored CW 
> Memory because I am lazy. Now I have to
> change mode from SSB to CW to get CW Memory ... and so on with the 
> next SSB-session answering a cw Station again.
>
> This is, for my understanding, a bit too much: Change mode, activate 
> cw keyer etc.
>
> Its easier to have "Extended CW memories" only for CW-IN-SSB in SSB-mode.
>