[Elecraft] Getting CW decoding to work (again)

[Tom Parish]

It's going to be one of those evenings. I'll try this again.

For some reason I've butterfingered the settings on my KX2 and for the life
of me I cannot get it to work in decoding mode. I keep looking at the KX2
manual on page 29 TEXT DECODE and DISPLAY to step through those
instructions but, no go.

The thing is the display shows a 'T' in the lower right hand corner
indicating it's on.  I'm in CW mode. I can hear CW coming through. I have
CWT activated but no matter what I do I cannot seem to see in any decoding
occuring. I just see  the numbers for the B receiver.

I can only imagine this is an embarrassingly simple remedy but I'm
befuddled at the moment.

Could someone email me your suggestions tom.parish at gmail.com.

Appreciatively
Tom


On Sun, Jul 16, 2017 at 8:50 PM, Tom Parish <tom.parish at gmail.com> wrote:

> For some reason I've butterfingered the settings on my KX2 and for the
> life of me I cannot get it to work in decoding mode. I keep looking at the
> KX2 manual on page 29
>
> The thing is the display is a show a 'T' in the lower right hand corner
> indicating it's on.  I'm in CW mode. I can hear CW coming through. I have
> CWT activated but no matter what I do I cannot seem to see in any decoding
> occuring. I just see  the numbers for the B receiver.
>
> I can only imagine this is an embarrassingly simple remedy but I'm
> befuddled at the moment.
>
> Can omeo
>
> --
>
> Inspire Curiosity Together
> Bildr <http://www.bildr.com> - no code programming platform
> 512-782-4814 <(512)%20782-4814> KB5RF
>
>
>
>
>
>
>
>


-- 

Inspire Curiosity Together
Bildr <http://www.bildr.com> - no code programming platform
512-782-4814 KB5RF