[Elecraft] [KX3] Re: New KX3 Beta Firmware, rev. 2.70: Various improvements

Don Wilhelm donwilh at embarqmail.com
Tue Feb 21 15:45:58 EST 2017


Ed,

I don't know what audio card you are using, but if it has a stereo plug 
on the KX3 end of the cable, it should not turn on PTT.
If it does, I suggest you make up a special cable with stereo plugs at 
both ends, and connect only the tip and shell of the plugs.
That should eliminate your problems with PTT being activated in DATA A mode.

73,
Don W3FPR

On 2/19/2017 1:20 PM, Edouard Lafargue edouard at lafargue.name [KX3] wrote:
>
>
>   Excellent news, Wayne!
>
>   If only you could consider making the "Mic Btn" settings
> mode-dependent, my life would be complete (or thereabouts). Right now
> this is the #1 setting I need to change all the time: when using the Mic
> on SSB I have to enable "Ptt", and when switching to DATA to connect my
> audio card for digital modes I need to set it to "Off" because the audio
> card jack I use keys PTT... :)
>
> 73 de ed w6ela
>
> On Fri, Feb 17, 2017 at 6:05 PM, Wayne Burdick <n6kr at elecraft.com
> <mailto:n6kr at elecraft.com>> wrote:
>
>     Hi all,
>
>     Beta firmware rev. 2.70 is now available on our KX3 software page.
>     See release notes below for details.
>
>     For instructions on installing beta releases, refer to our KX3
>     software page. (Beta releases are not automatically recognized by
>     KX3 Utility.)
>
>     73,
>     Wayne
>     N6KR
>
>     * * *
>
>
>     MCU 2.70 / DSP 1.49, 2-17-2017
>
>     * AM TX BANDWIDTH INCREASED: The AM transmit bandwidth is now
>     approximately 100-4000 Hz (was 100-3000). TX EQ can be used to
>     further shape the passband.
>
>     * AM TX ALC IMPROVEMENTS: Fixed a bug in the AM power-control
>     algorithm that was causing power output to start too high, then
>     decrease over time when the operator is speaking. In addition, peak
>     power output is now displayed, rather than power/4 (25%). This is
>     intended to make the operator aware of the actual output from the
>     radio, which accounts for the observed current drain, stress on
>     dummy loads or antennas, etc.
>
>     * SCANNING WORKS WITH FREQUENCIES BELOW 1.0 MHz. Previously,
>     scanning would stall in this case.
>
>     For software developers:
>
>     * DT, FR, and FT HOST COMMANDS DISALLOWED IN TX MODE: Previously,
>     these commands (data submode, unsplit, and split) could be sent to
>     the K3 during transmit from software applications. This could
>     sometimes cause side effects such as muting of transmit audio in
>     DATA modes.
>
>     * RIT CLEAR SWITCH UPDATES RIT OFFSET AT PX3 PANADAPTER.
>
>     * POWER-OUTPUT CONTROL COMMAND (“PC”) FIXED: The PC command now
>     correctly handles the KX3’s power ranges (up to 12 W or 15 W
>     depending on band).
>
>     * PSK31/PSK63 SELECTION (ETC.) VIA REMOTE COMMAND: When the DATA
>     submode is being modified under remote control, a software
>     application can now select between PSK31/PSK63 using the UP/DN
>     control commands. Similarly, UPB/DNB can be used to select the
>     desired TEXT decode mode (DEC OFF, TX ONLY, RX THRn). To determine
>     the current state of any of these parameters, use the DS or DB
>     commands. Refer to the Programmer’s Reference.
>
>     ______________________________________________________________
>     Elecraft mailing list
>     Home: http://mailman.qth.net/mailman/listinfo/elecraft
>     <http://mailman.qth.net/mailman/listinfo/elecraft>
>     Help: http://mailman.qth.net/mmfaq.htm
>     <http://mailman.qth.net/mmfaq.htm>
>     Post: mailto:Elecraft at mailman.qth.net <mailto:Elecraft at mailman.qth.net>
>
>     This list hosted by: http://www.qsl.net
>     Please help support this email list: http://www.qsl.net/donate.html
>     Message delivered to edouard at lafargue.name
>     <mailto:edouard at lafargue.name>
>
>
> __._,_.___
> ------------------------------------------------------------------------
> Posted by: Edouard Lafargue <edouard at lafargue.name>
> ------------------------------------------------------------------------
> Reply via web post
> <https://groups.yahoo.com/neo/groups/KX3/conversations/messages/61225;_ylc=X3oDMTJyajdtOG5iBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARtc2dJZAM2MTIyNQRzZWMDZnRyBHNsawNycGx5BHN0aW1lAzE0ODc1Mjg0NTI-?act=reply&messageNum=61225>
> 	• 	Reply to sender
> <mailto:edouard at lafargue.name?subject=Re%3A%20%5BElecraft%5D%20New%20KX3%20Beta%20Firmware%2C%20rev%2E%202%2E70%3A%20Various%20improvements>
> 	• 	Reply to group
> <mailto:KX3 at yahoogroups.com?subject=Re%3A%20%5BElecraft%5D%20New%20KX3%20Beta%20Firmware%2C%20rev%2E%202%2E70%3A%20Various%20improvements>
> 	• 	Start a New Topic
> <https://groups.yahoo.com/neo/groups/KX3/conversations/newtopic;_ylc=X3oDMTJma2ZxdWo3BF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDZnRyBHNsawNudHBjBHN0aW1lAzE0ODc1Mjg0NTI->
> 	• 	Messages in this topic
> <https://groups.yahoo.com/neo/groups/KX3/conversations/topics/61206;_ylc=X3oDMTM3bjYzdGdnBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARtc2dJZAM2MTIyNQRzZWMDZnRyBHNsawN2dHBjBHN0aW1lAzE0ODc1Mjg0NTIEdHBjSWQDNjEyMDY->
> (2)
>
> ------------------------------------------------------------------------
> Have you tried the highest rated email app? <https://yho.com/1wwmgg>
> With 4.5 stars in iTunes, the Yahoo Mail app is the highest rated email
> app on the market. What are you waiting for? Now you can access all your
> inboxes (Gmail, Outlook, AOL and more) in one place. Never delete an
> email again with 1000GB of free cloud storage.
> ------------------------------------------------------------------------
> Visit Your Group
> <https://groups.yahoo.com/neo/groups/KX3/info;_ylc=X3oDMTJma2ZybHRtBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2Z2hwBHN0aW1lAzE0ODc1Mjg0NTI->
>
>
>   * New Members
>     <https://groups.yahoo.com/neo/groups/KX3/members/all;_ylc=X3oDMTJncDlucTUzBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2bWJycwRzdGltZQMxNDg3NTI4NDUy>
>     12
>   * New Photos
>     <https://groups.yahoo.com/neo/groups/KX3/photos/photostream;_ylc=X3oDMTJnNDYxNnVrBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2cGhvdARzdGltZQMxNDg3NTI4NDUy>
>     1
>
> Yahoo! Groups
> <https://groups.yahoo.com/neo;_ylc=X3oDMTJlM2JqbXZhBF9TAzk3NDc2NTkwBGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDZnRyBHNsawNnZnAEc3RpbWUDMTQ4NzUyODQ1Mg-->
>
> • Privacy <https://info.yahoo.com/privacy/us/yahoo/groups/details.html>
> • Unsubscribe
> <mailto:KX3-unsubscribe at yahoogroups.com?subject=Unsubscribe> • Terms of
> Use <https://info.yahoo.com/legal/us/yahoo/utos/terms/>
>
> .
>
> __,_._,___


More information about the Elecraft mailing list