[Elecraft] K3: TX Gain Calibration Summary

[Don Wilhelm]

Dick,

I think all is well, as long as the TX Gain Calibration succeeded.
What you are seeing in the summary is the gain factor for each band.
The RF Gain is not constant from one band to another, but after a 
successful calibration routine, those values are used by the firmware to 
compute the amount of drive needed to achieve whatever power output you 
requested with the power knob.

73,
Don W3FPR

On 2/18/2017 3:56 PM, Dick Dickinson wrote:
> I've just done a TX Gain Calibration.  The numbers shown TX Gain Calibration
> Summary vary quite a bit.  What is the proper way to interpret them?