[Elecraft] Mayday K3 no receive power output solved

[W0MU Mike Fatchett]

Z3 board came loose and probably damaged.  Removed and soldered a jumper 
re Elecraft support.  We have power.

Nothing on receive yet.  Triple checking on the tmp cables etc as I have 
had the radio apart many times.

AGC, pre amp seem to have no effect.  Receive on the xvter board is also 
dead.

W0MU


On 2/16/2017 10:00 AM, Petr, OK1RP/M0SIS wrote:
> Ken,
>
> first-aid idea (as you said both RXs dead and Cal failed...) :
>
> 1. Turn ON K3
> 2. On the K3 front panel, hold CONFIG menu and turn tech mode on (CONFIG:
> TECH MD ON).
> 3. Tap MENU to exit the menu and then tap DISP on the K3 front panel.
> 4. Rotate the VFO B knob to display SYN1 in the VFO B area of the display.
> You should see the
> status OK. the same for SYN2 status OK after...
>
> If there is no OK status of both synths then check the all TMP coax cables
> from and to the synths boards and check if synths boards seats well in the
> multi-pins headers...
>
> 73 - Petr, OK1RP
>
>
>
> -----
> http://ok1rp.blogspot.com
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Fwd-Mayday-K3-no-receive-no-output-tp7626976p7626985.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w0mu at w0mu.com