[Elecraft] K3S and Heil PR10

[Don Wilhelm]

The real bottom line is to use the indication on the K3 (K3S, KX3 and 
KX2) ALC meter.
If you are driving the voice audio up to the 5 to 7 bars level, that is 
correct.  If it is going higher reduce the MIC gain or switch to the low 
mic gain setting.

If it is lower than the 5 to 7 bars, increase the mic gain or switch to 
the high mic gain range.

73,
Don W3FPR

On 2/11/2017 10:28 PM, RIchard Williams wrote:
> Tom,
>
> I would use whatever setting works the best; if you are receiving good 
> audio reports, "leave sleeping dogs lie".  If your mic gain is set at 
> something reasonable (mine is "9"), I wouldn't worry about what is 
> "suggested".  Too many variables with your voice characteristics; if 
> you are calling a "P5" for an ATNO, you might be speaking a bit louder 
> than working a JA for the 300th time.
>