[Elecraft] P3 showing sigs on Aux antenna in diversity mode?

[Don Wilhelm]

Bill,

The only way I know of is to dig into the SubRX and connect its IF 
output to the P3.  The buffer circuit is there, but is not brought out 
of the SubRX enclosure.

I don't know of an easy way to transfer the P3 input between the main 
and the SubRX, but myself, I would simply use a relay external to the K3 
and operate it manually when you want to make the switch.

73,
Don W3FPR

On 12/30/2017 7:25 PM, Bill Conwell wrote:
> For 160, I've got a noisy TX antenna, and a quiet RX antenna.  I sometimes
> run them in diversity mode, with TX antenna connected to K3's ANT1 port,
> and RX antenna connected to AUX port.
> 
> Diversity works fine.
> 
> But the P3 shows the IF from the noisy TX antenna - in which many weak
> stations are obscured by noise.
> 
> Is there any configuration by which I can get P3 to show, instead, the
> signals from the quiet RX antenna (connected to AUX input)?