[Elecraft] K3 RX Equalizer

[Chris Hallinan]

Hi, Lyle.

Thanks for helping me understand the K3 even better ;)

I'm working on building a remote solution using remotehams.com software.  I
hope I can use my SignaLink USB as the TX/RX audio interface to the
server.  I can hear very nicely on the remote (same room still!), but the
transmit audio seems very low.  Basically I've set MIC SEL to LineIn, and
selected my SignaLink USB as the audio source for the server.  I'm still
experimenting with levels, etc, and that's what led to the question.

Best regards,

Chris
K1AY


On Fri, Dec 29, 2017 at 12:04 PM, Lyle Johnson <kk7p4dsp at gmail.com> wrote:

> Yes.
>
> 73,
>
> Lyle KK7P
>
>
> On 12/29/17 9:53 AM, Chris Hallinan wrote:
>
>> I understand that the K3 has two separate equalizer settings for CW and
>> SSB.  I also understand it is not active in the Data modes.
>>
>> However, there are four sources of audio output:
>>
>> 1) Internal Speaker
>> 2) SPKRS (rear panel)
>> 3) Phones (front panel)
>> 4) Line Out (rear panel)
>>
>> Does the equalizer operate for all four outputs?
>>
>> Thanks,
>>
>> Chris
>> K1AY
>>
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to challinan at gmail.com
>



-- 
Life is like Linux - it never stands still.