[Elecraft] K3S Initial setup calibration problem

[TKNorris]

Hi Alan,
I am also a new K3S owner/assembler. I had the same symptoms after powering
up the K3S the first time, no errors (that later resolved itself and I
received the KPA3A alert after clearing with Display button and power
cycling several times during Filter Configuration - have 2.8kHz, FM &
400hz). I have also been puzzled by not hearing any signals at this point on
any band, just the noise. However, during the troubleshooting of the
Wattmeter calibration I listened and transmitted with an old Ten Tec Omni D,
I did hear the Omni transmit on the K3S receive and visa versa while
transmitting during the K3S Wattmeter Calibration.
Get a good night's rest and we will press on later!

Tom NB5Q



--
Sent from: http://elecraft.365791.n2.nabble.com/